Controllers For Injection Moulds With Heated Channels

We are exporting, distributing, manufacturing and supplying of Controllers For Injection Moulds With Heated Channels from Chongqing, China.

About Product:-

Complete set for temperature control in injecti on
moulds with heated channels.
a c System equiped with 1 or up to 8 controllers in one
housing (depending on the version).
a c Built-in 15 A SSR output for each control zone
(output resoluti on: 0.1 A).
a c PID control wit autotuning and Fuzzy logic algorithm
ensuring a high temperature control accuracy and
opti mal energy consumpti on.
a c a Soft starta functi on enables the mould preheati ng.
a c Monitoring of the leakage current of heater.
a c Signalling of breaks, short-circuits and inverse polari-
zati on of the sensor.
a c Measurement of the heater leakage current and
detecti on of the maximal current exceeding.
a c Measurement of the load current, detecti on and
damage signalling.
a c Emergency work mode aft er the thermocouple
damage with a mean power delivered before
the damage with a mean power delivered before
the damage or with the output turned off .
a c RS-485 interface with MODBUS protocol (ASCII and
RTU modes) for connecti on with PC, recorders
or other Modbus devices.
a c Decreased temperature mode (remote acti vati on
with logic input or local acti vati on using the butt ons).
a c Relay output to signal the alarm states.