Heat Seal Connector Application: Lcd Display Related Materials

1, the work surface is crimped there should be no oil, moisture, oxide, perspiration, should be kept clean and dry.
2, not too early to remove the protective paper hot paper, should be exposed with the use, to prevent pollution.
3, the workpiece should be placed in a stable, cushion strong, should pay particular attention to parallel contact with the hot head.
4, the pressure is connected to the temperature of the conductive silicone mold head of the actual temperature, rather than referring to the original temperature sensor temperature, it
The difference between the random values, the thickness of the die head and the ambient temperature are different.
5, to have enough hot pressing time, generally should not be less than 4 seconds.
6, to have enough temperature, generally for 130 degrees - 140 degrees C (silicone mold head of the actual temperature) do not dial temperature
Degree prevail. Pressure is 35~45kg.
7, HSC connnector should be placed in a cool, ventilated place, not stress, avoid moisture.
8, HSC connnector in the use of the process, in addition to providing reference data by the supplier, the customer must be based on the effect of hot pressing
To make adjustments, according to the following procedures: (please check the thermal conductivity and the corresponding glass pin
Constant pressure, temperature, time is in place, hot pressing position is correct, to avoid pressure on the glass edge or the bottom of the gold
It is on the edge of the end that leads to a wire cutting
(1) if there is a broken line (commonly known as broken carbon) and hot pressing is not strong at the same time, the display hot pressing temperature is too high, will
Must be substantially reduced, down about 10 degrees Celsius, until the phenomenon disappeared, and then do fine-tuning.
(2) if there is a broken line, but the hot press firmly, showing the hot press temperature is too high, please lower the temperature, each drop
5 degrees Celsius, until the phenomenon disappeared, and then do fine tuning.
(3) such as hot pressing is not strong, easy to break off, in the LCD, the gold finger to keep the carbon poor; but no broken line phenomenon shows
Temperature is not enough (hot die temperature), please raise the temperature until the phenomenon disappears, then do fine adjustment.