Kemclean-k-11(low Temperature Alkaline Degreasing

                                                                             Low Temperature Alkaline Degreasing Compound Product DescriptionWe offers our customers Kemclean-K-11(Low Temperature Alkaline Degreasing Compound). Kemclean-K-11 is specially formulated for the removal of oil, grease, dirt and other foreign contaminants from the surfaces of the ferrous metals. This product is generally used to remove light duty oil and grease, by dip hot application. Product Specifications a. Colour White Powder b. Chemical Composition Blend of sodium salt of carbonate, bi-carbonate, Hydroxide, Phosphates, silicate surface activators emulsifiers etc. c. Odour Nil d. Foaming Tendency Moderate e. Reliability Good f. Handling Avoid Skin Contact g. Solubility Good h. pH Alkaline Range I. Toxicity Nil j. Flash Point Nil k. Pollution Hazard Moderate Product Operating Data Concentration 5% Pointage 40 - 45 ml. Dip Time 10 min. Temperature 45 - 60oC Product Operating Procedure Fill the Kemclean K-11 tank with 2/3 of water and heat it about 45oC. Add 5% of Kemclean-K-11 powder with continuous agitation till the chemicals completely dissolve. Fill the tank to the operating level and raise the temperature. Stir the bath and draw the bath sample for the determination of pointage. Strength of Kemclean-K-11 bath can be increased if the components are heavily contaminated with heavy oil or grease. It is therefore advisable that heavily contaminated components should be pre-dipped in soak cleaner or emulsion cleaner, which may help to remove the oil/grease from the surface of the components within very short time, ultimately pre-dip cleaning will also help to increase the life of the degreasing bath. Maintenance of the temperature is also very important factor. If the temperature of the bath is low the efficiency of the degreasing chemical will be effected even if the concentration and the treatment time are increased. The components should be thoroughly rinsed with over flowing system until unless Kemclean-K-11 is completely removed. Product Application EquipmentKemclean-k-11 tank should be fabricated with 3 to 4 mm thick M. S. Plates with continuous agitation arrangement and convection heating system. Testing and Control ProcedurePipette out 5 ml. of the bath solution into a conical flask. Add 2 to 3 drops indicator methyl orange. Titrate against N/10 sulfuric acid, Hydro choleric acid till the colour changes from yellow to red. The burette reading is the pointage. The pointage of the degreasing should always be maintained at the recommended level. Chemical ReplenishmentThe efficiency of the degreasing bath falls due to the carry over of oils coming from work which gets emulsified in the bath solution and presence of the sludge at the bottom. At this Kemclean-K-11 bath should be discarded. Safety MeasuresKemclean-k-11 contact with skin, eyes, mouth and clothing should be avoided and proper safety precautions should be taken by the operators, by using gloves, goggles and safety clothing. General InformationPaint Adhesion: GoodGloss Retention: Good.