Alkaline Degreasing Compound

                                                                            Alkaline Degreasing Compound Kemclean-501(Alkaline Degreasing Compound) is an alkaline degreasing chemical used for the removal of light oil and grease, from ferrous surfaces by spray or jetting process. It is recommended specially to remove the excess oil and grease initially by solvent wiping or by high pressure cold water spray to increase the bath life of Kemclean-501(S). It is suitable for degreasing CRCA, galvanized and ternne coated sheets effectively. Product Specifications a. Colour Light Pale Yellow Powder b. Chemical Composition Blend of sodium salt of carbonate, bi-carbonate, Hydroxide, Phosphates, Silicate surface activators emulsifiers etc. c. Odour Nil d. Foaming Tendency Moderate e Reliability Good f. Handling Avoid Skin Contact g Solubility Good h. pH Alkaline Range i. Toxicity Nil j. Flash Point Nil k. Pollution Hazard Moderate Product Operating Data Concentration 2.5 kgs. Per 100 ltr/bath Pointage 16 - 20 ml. Time 60 - 150 secs Temperature 45 - 50oC Spray Pressure 1.2 -1.4 kgm/cm2 Product Operating Procedure Fill the Kemclean-501(s) tank with in the 2/3 of water and heat it upto 45oC, and then add required amount of Kemclean-501(c) with continuous stirring at the time of addition. Fill the tank bath to the operating level and increase the temperature 45-50oC. Stir the bath solution well to determine the pointage whether it is up to the recommended concentration or not the adjust the bath accordingly. Thorough rinsing is required after in Kemclean-501(s) preferably in two stages for the complete removal of Kemclean-501(C) solution from the surface of the works. Generally in the spray process, degreasing is used in two stages i.e. Knock off degrease Degrease In this case, knock off degreasing gets contaminated very fast as compared to degrease bath. Ultimately (KOD) bath should be discarded once in a week and degrease bath should be transferred into (KOD) tank bath, degreasing bath should be prepared fresh in order to save the chemical consumption. Product Application EquipmentKemclean-501(S) tank should be fabricated with 3-4 mm thick M.S. Plates with continuous convection current heating from the heating source and continuous agitation system. Testing and Control Procedure Pipette out 10 ml. of the bath solution into a conical flask.Add 90 ml of water to make it 100ml Titrate it with N/10 Hcl or N/10 H2SO4 by using Methyl orange indicator till colour changes from yellow to red. 7.0 Chemical Replenishment The pointage of the degreasing bath is to be maintained at the recommended level. The efficiency of the degreasing bath falls due to the oil coming out after work, which is emulsified in the running solution and settles as sludge at the bottom. At this stage Kemclean-501(S) should be discarded. Safety MeasuresKemclean-501(s) contact with eyes, and clothing should be avoided and proper safety precautions are to be taken by operators, by using gloves, goggles and safety clothing's. In case of accident the effected parts should be continuously flushed with plenty of water and immediately consult a physician. General InformationPaint Adhesion: GoodGloss Retention: Good.