Canfiber-100 Series

For creating star or tree topologies, several CANFiber-100 Series can be connected to a CAN-hub via the integrated backbone bus (also in conjunction with CANFiber-100). One special feature of the repeater is, that it separates a defective segment from the rest of the network, so that the remaining network can continue working. After elimination of the defect, the segment is switched into the network again. The CANFiber-100 Series is used for the conversion of the CAN signal from copper wire (ISO 11898-2) to fiber optic cables. This provides a complete isolation and protection against EM-influences.
Converter from ISO 11898-2 to fiber optic cable
CAN 2.0A and CAN 2.0B supported
CAN transfer rate up to 1 Mbps
3KV Galvanic isolation protection, 2.5KV Signal isolation protection.
LED for transmit/receive status on each port
Optional 120 ohm terminal resistor for CAN bus network
Extended operating temperature range from -40 to 85 A C
Fiber communications
1 channel fiber port
1 or 2 fiber Connectors,ST/SC/FC selectable
Optical wavelength
850nma 1310nma 1550nm
Fiber mode
Multi-mode: 62.5/125um; single-mode: 9/125um
Fiber transmission distance
0 to 4km with multi-mode; 0 to 60km with single-mode
CAN Specification
CAN 2.0 A/B
CAN Specification
CAN 2.0 A/B
Transfer Rate
1 Mbps
Signal Support
CANHi CANLi GND
Connectors
1 channel, OPEN6
Optical Isolation
3000V DC-DC Isolationi 2500V Signal isolation